Parkzone PKZU2480 Bedienungsanleitung PDF herunterladen (Seite 7)

7

EN

Preﬂ ight Checklist

Installing the Flight Battery and Arming the ESC

9

1. Charge the ﬂ ight battery.

2. Install the ﬂ ight battery in the

aircraft (once it has been fully

charged).

3. Bind the aircraft to the transmitter.

(BNF only)

4. Make sure the linkages move freely.

9

5. Perform the Control Direction Test

with the transmitter.

6. Adjust the center of gravity.

7. Perform a radio system Range Check

8. Find a safe and open area.

9. Plan ﬂ ight appropriate for ﬂ ying

location.

Arming the ESC also occurs after binding as

previously described, but subsequent connection

of a ﬂ ight battery requires the following steps.

AS3X

The AS3X® system will not activate until the

throttle stick or trim is increased for the ﬁ rst

time. Once active, the control surfaces may

move rapidly and noisily on the aircraft.

This is normal. AS3X technology will remain

active until the battery is disconnected.

It is normal for linear servos to make noise. Noise

is not an indication of a faulty servo.

CAUTION: Always keep hands away

from the propeller. When armed, the motor will

turn the propeller in response to any throttle

movement.

CAUTION: Always disconnect the Li-Po

battery from the aircraft receiver when not

ﬂ ying to avoid over-discharging the battery.

Batteries discharged to a voltage lower than

the lowest approved voltage may become

damaged, resulting in loss of performance and

potential ﬁ re when batteries are charged.

3

2

1

1-2-3-4-5 Sec.

Lower throttle and

throttle trim to

lowest settings.

Power ON the

transmitter, then

wait 5 seconds

Connect the

battery to the ESC,

noting proper

polarity.

Keep the plane

immobile and

away from wind

for 5 seconds.

Continuous LED

Secure the battery

to the hook and

loop strip on the

battery holder.

FLY...

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Kommentare zu diesen Handbüchern

Keine Kommentare