ParkZone ICON A5 PNP Bedienerhandbuch

Instruction Manual • Bedienungsanleitung • Manuel d’utilisation • Manuale di IstruzioniICON, the ICON logo, ICON A5 and its body design are trademarks

ENBind your aircraft and transmitter before doing these tests. Move the controls on the transmitter to make sure the aircraft control surfaces move co

ENDisassembly 1. Remove the screw (A) and spinner (B) from the collet shaft (G). 2. Use a tool to remove the spinner nut (C) from the collet shaft.

ENRange Check your Radio SystemAfter fi nal assembly, range check the radio system with the ICON A5. Refer to your specifi c transmitter instruction man

ENPlease see your local or regional modeling association’s guidelines for proper, safe operation of your model aircraft.Effective January 1, 2011A. GE

ENProblem Possible Cause SolutionAircraft will not respond to throttle but responds to other controlsThrottle is not at idle and/or throttle trim is t

ENWhat this Warranty CoversHorizon Hobby, Inc. (“Horizon”) warrants to the original purchaser that the product purchased (the “Product”) will be free

ENDeclaration of Conformity(in accordance with ISO/IEC 17050-1) No. HH2011073001Product(s): ICON A5 BNF Item Number(s): PKZ5880Equipment clas

Part # | NummerNuméro | CodiceDescription Beschreibung Description DescrizionePKZ5801Prop with Spinner: ICON A5 Propeller mit Spinner: ICON A5 Cône av

Optional Parts • Optionale Bauteile • Piéces optionnelles • Pezzi opzionali* All Spektrum DX8 transmitters can be set up for modes 1–4* Alle Spektrum

© 2011 Horizon Hobby, Inc.ParkZone, DSM, DSMX, DSM2, ModelMatch, Bind-N-Fly, Z-Foam and Plug-N-Play are trademarks or registered trademarks of Horizon

ENENAdditional Safety Precautions and WarningsAs the user of this product, you are solely responsible for operating in a manner that does not endanger

ENENTo register your product online, visit www.parkzone.comWelcome to the world of amphibious RC fl ight! Even if this isn’t your fi rst fl oat plane exp

ENENCharging the Flight BatteryThe Battery Charging Process1. Charge only batteries that are cool to the touch and are not damaged. Look at the batte

ENEN1. Carefully lift the back of the canopy hatch (A) and pull hatch pins from the holes in the fuselage to remove the hatch. 2. Install fl ight bat

EN1 2 3• Lower throttle and throttle trim to lowest settings.• Connect battery to ESC.Continuous LEDSeries of tonesPower on TransmitterWait 5 second

EN1. Put the wing tube (A) into the hole in the wing slot of the fuselage.2. Put the right wing on the wing tube.3. Move the wing on the tube in

ENMain Gear Installation1. Turn the model over so the bottom faces up.2. Install the rear right and left landing gear struts (A) in the fuselage u

ENTip: Turn the clevis clockwise or counterclockwise on the linkage. • Pull the tube from the clevis to the linkage.• Carefully spread the clevis an