Parkzone PKZ6250 Bedienungsanleitung

Focke-Wulf 190AInstruction Manual / Bedienungsanleitung Manuel d’utilisation / Manuale di Istruzioni

ENThe CG location is 74mm back from the leading edge of the wing. Install the recommended fl ight battery with the end of the battery aligned with the

ENMove the controls on the transmitter to make sure the aircraft control surfaces move correctly and in the proper direction. After performing the Con

ENDual RatesYour DSM2/DSMX full range transmitter features dual rates to help you select the amount of travel that you want from the control surfaces.

ENDisassembly CAUTION: Always disconnect the fl ight battery from the aircraft before removing the propeller. 1. Remove the screw (A) and spinner (B)

ENPlease see your local or regional modeling association’s guidelines for proper, safe operation of your model aircraft.Effective January 1, 2011A. GE

ENProblem Possible Cause SolutionAircraft will not re-spond to throttle but responds to other controlsThrottle not at lowest position or throttle trim

ENWhat this Warranty CoversHorizon Hobby, Inc. (“Horizon”) warrants to the original purchaser that the product purchased (the “Product”) will be free

ENDeclaration of Conformity(in accordance with ISO/IEC 17050-1) No. HH2013041301U1Product(s): PKZ Focke-Wulf 190A BNF BasicItem Number(s): PKZ

Country of Purchase Horizon Hobby Address Phone Number/Email AddressUnited States of America Sales4105 Fieldstone RdChampaign, Illinois 61822 USA888-

Optional Parts • Optionale Bauteile • Pièces optionnelles • Pezzi opzionaliPart # | NummerNuméro | CodiceDescription Beschreibung Description Descrizi

ENNOTICEAll instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-dat

© 2013 Horizon Hobby, Inc. ParkZone, E-flite, Celectra, EC3, DSM, DSM2, DSMX, Z-Foam, Bind–N–Fly, Plug-N-Playand ModelMatch are trademarks or registe

ENTo register your product online, visit www.parkzone.comYou are just a few simple steps away from taking fl ight with this impressive replica of one o

EN“Binding” is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er) code of a single specifi c transmitter. You n

EN1. Push the button (A) into the fuselage, releasing the battery latch.2. Lift the back of the battery hatch and pull backwards to remove the bat

ENNOTICE: Always ensure the retracts and wheels are installed so that there are no obstructions when extending and retracting the struts. Failure to d

ENFactory SettingsHorns ArmsElevatorRudderAileronsControl Horn and Servo Arm Settings1. Remove the battery hatch from the fuselage using the latch b

EN1. Remove the factory-installed payload mount (A) and 2 screws (B) from the drop tank fairing located on the bottom of the wing. 2. Install the s

ENFixed Landing Gear Installation1. Install the left and right fi xed landing gear (A) in the respective mounting plates (B).2. Install the left an